CD3(T細胞)兔單克隆抗體

廣州健侖生物科技有限公司

CD3是一種能直接與T細胞抗原受體(TCR)相連的蛋白質復合物，與TCR組成復合受體分子，是T細胞識別抗原的主要識別單位，具有穩定TCR 結構和傳遞活化信號的作用，是幼稚和成熟T細胞的的標志之一。此抗體可用于T細胞淋巴瘤的研究。

我司還提供其它進口或國產試劑盒：登革熱、瘧疾、流感、A鏈球菌、合胞病毒、腮病毒、乙腦、寨卡、黃熱病、基孔肯雅熱、克錐蟲病、違禁品濫用、肺炎球菌、軍團菌、化妝品檢測、食品安全檢測等試劑盒以及日本生研細菌分型診斷血清、德國SiFin診斷血清、丹麥SSI診斷血清等產品。

歡迎咨詢

歡迎咨詢

【產品介紹】

細胞定位：細胞膜

克隆號：MRQ-39

同型：IgG

適用組織：石蠟/冰凍

陽性對照：扁桃體

抗原修復：熱修復（EDTA）

抗體孵育時間：30-60min

CD3(T細胞)兔單克隆抗體

2、細胞大小的測定
⑴將酵母菌斜面制成一定濃度的菌懸液（10－2）。
⑵取一滴酵母菌菌懸液制成水浸片。
⑶移去鏡臺測微尺，換上酵母菌水浸片，先在低倍鏡下找到目的物，然后在高倍鏡下用目鏡測微尺來測量酵母菌菌體的長，寬各占幾格，不足一格的部分估計到小數點后一位數。測出的格數乘上目鏡測微尺每格的校正值，即等于該菌的長和寬。一般測量菌體的大小要在同一個標本片上測定10～20個菌體，求出平均值，才能代表該菌的大小。待測微生物需用培養至對數生長期的菌體進行測定。
⑷同樣方法用油鏡測定枯草桿菌染色標本的細胞大小。
（二）微生物細胞的顯微直接計數法
1、視待測菌懸液濃度，加無菌水適量稀釋（斜面一般稀釋到10－2），以每小格的菌數可數為度。
2、取潔凈的血球計數板一塊，在計數區上蓋上一塊蓋玻片。
3、將酵母菌懸液搖勻，用滴管吸取少許，從計數板中間平臺兩側的溝槽內沿蓋玻片的下邊緣滴入一小滴，不宜過多，讓菌懸液利用液體的表面張力充滿計數區，勿使氣泡產生，并用吸水紙吸去溝槽中流出的多余菌懸液。也可以將菌懸液直接滴加在計數區上，注意不要使計數區兩邊平臺沾上菌懸液，以免加蓋蓋玻片后，造成計數區深度的升高。然后加蓋蓋玻片，勿使產生氣泡。
4、靜置片刻，將血球計數板置載物臺上夾穩，先在低倍鏡下觀察到計數區后，再轉換高倍鏡觀察并計數。由于活細胞的折光率和水的折光率相近，觀察時應適當關小孔徑光闌并減弱光照的強度。
5、計數時若計數區是由16個大方格組成，按對角線方位，數左上、左下、右上、右下的4個大方格（即100小格）的菌數。如果是25個大方格組成的計數區，除數上述四個大方格外，還需數中央1個大方格的菌數（即80個小格）。如菌體位于大方格的雙線上，計數時則數上線不數下線，數左線不數右線，以減少誤差。
6、對于出芽的酵母菌，芽體達到母細胞大小一半時，即可作為兩個菌體計算。每個樣品重復計數2～3次，每次數值不應相差過大，否則應重新操作，求出每一個小格中細胞平均數（N），按公式計算出每mL(g)菌懸液所含酵母菌細胞數量。
7、測數完畢，取下蓋玻片，用水將血球計數板沖洗干凈，切勿用硬物洗刷或抹擦，以免損壞網格刻度。洗凈后自行晾干或用吹風機吹干，放入盒內保存。

CD3(T細胞)兔單克隆抗體

我司還提供其它進口或國產試劑盒：登革熱、瘧疾、流感、A鏈球菌、合胞病毒、腮病毒、乙腦、寨卡、黃熱病、基孔肯雅熱、克錐蟲病、違禁品濫用、肺炎球菌、軍團菌、化妝品檢測、食品安全檢測等試劑盒以及日本生研細菌分型診斷血清、德國SiFin診斷血清、丹麥SSI診斷血清等產品。

想了解更多的產品及服務請掃描下方二維碼：

【公司名稱】 廣州健侖生物科技有限公司
【市場部】    楊永漢

【】 
【騰訊  】 
【公司地址】 廣州清華科技園創新基地番禺石樓鎮創啟路63號二期2幢101-103室

2, the determination of cell size
⑴ yeast slant made a certain concentration of bacterial suspension (10-2).
⑵ take a drop of yeast suspension made of water immersion tablets.
⑶ remove the mirror micrometer scale, put the yeast immersion film, first find the object at low magnification, and then under high magnification with eyepiece micrometer to measure the length and width of yeast cells, each of several grid , Less than a single part of the estimated number of decimal places. Multiply the number of cells measured by each eyepiece micrometer ruler calibration, that is equal to the length and width of the bacteria. General measurement of the size of the cells in the same specimen measured 10 to 20 cells, to find the average, in order to represent the size of the bacteria. The microorganisms to be tested need to be cultured to the logarithmic growth phase.
⑷ the same method with the oil microscope to determine the cell size of B. subtilis stained specimens.
(B) Micro-cell direct micro-counting method
1, depending on the concentration of bacterial suspension test, add appropriate amount of sterile water dilution (beveled generally diluted to 10-2), in order to count the number of bacteria per cell for the degree.
2, take a clean blood count plate, covered in a count area cover glass.
3 shake the suspension of yeast, with a little pipette, counting plate from the middle of the groove on both sides of the cover along the bottom edge of a small drop, not too much, so that the bacterial suspension of liquid Of the surface tension is full of counting area, do not make bubbles, and use suction paper to absorb excess bacteria in the trench suspension. The bacterial suspension can also be dropped directly on the counting area, be careful not to make the platform on both sides of the counting area stained with bacterial suspension, so as not to cover the cover glass, resulting in increased count zone depth. Then cover with glass, do not make bubbles.
4, let it stand for a moment, the hemocytometer plate set on stage stationary, first observed under low magnification count area, and then converted to observe and count high magnification. Due to the refractive index of living cells and water similar to the observation should be appropriate off aperture aperture and reduce the intensity of light.
5, counting the count area is composed of 16 large square, according to the diagonal line, the number of upper left, lower left, upper right, lower right of the four large grid (ie 100 small cell) bacteria. If it is a counting area composed of 25 large squares, in addition to the above four large squares, it also needs to count the number of bacteria in one large square in the center (ie, 80 small squares). Such as bacteria located in the large double-line grid, count the number of on-line countless off the assembly line, the number of left-right line on the right to reduce the error.
6, budding yeast, bud body to half the size of the mother cell, you can calculate as two cell body. Repeat counting for 2 ~ 3 times for each sample, each value should not differ too much, or should be re-operated to calculate the average number of cells (N) in each cell, according to the formula to calculate the bacterial suspension Yeast cells contained in the number.
7, the test is completed, remove the coverslip, water to wash the blood count plate, do not use hard objects to scrub or wipe, so as not to damage the grid scale. Wash yourself or dry with a hair dryer, into the box to save.